All -
A somewhat simple question for ya'll. I had some ideas, but wanted to make sure I wasn't overthinking this problem.
My newly acquired Stohr doesn't have the rear wing attached to the body like the Radical did, meaning that getting the rear deck off by myself is almost impossible. I'm fairly short, and as such, have fairly short arms, so I can't grab at either ends like some can, I think.
I don't know yet if I can get it back on OK (haven't tried this yet).
At any rate, I was considering something simple like glassing in a small threaded insert to be able to attach a small handle or eyebolt to for when I need to remove the body on my own - put it near the middle/rear of the body so I can lift it. Or, more simply, a small hole/slot or two that might double with getting some hot air out of the engine bay.
Or, is there a lot simpler answer to this that I'm overlooking?
Thanks,
-Jake
A somewhat simple question for ya'll. I had some ideas, but wanted to make sure I wasn't overthinking this problem.
My newly acquired Stohr doesn't have the rear wing attached to the body like the Radical did, meaning that getting the rear deck off by myself is almost impossible. I'm fairly short, and as such, have fairly short arms, so I can't grab at either ends like some can, I think.
I don't know yet if I can get it back on OK (haven't tried this yet).
At any rate, I was considering something simple like glassing in a small threaded insert to be able to attach a small handle or eyebolt to for when I need to remove the body on my own - put it near the middle/rear of the body so I can lift it. Or, more simply, a small hole/slot or two that might double with getting some hot air out of the engine bay.
Or, is there a lot simpler answer to this that I'm overlooking?
Thanks,
-Jake

















